Double Sided FLEX-display Stand 2 Graphics Back To Back On Crossbase System

Adjustable Height Telescopic Pole

Wall Mounted FLEX-display Fabric Graphic

Ceiling Hanging FLEX-display Fabric Graphics

FLEX-display Low Voltage Spotlight

More Backdrop Choices For You

In most cases, we have mentioned that our displays may be double sided, may be taller and could be fitted with baseplates rather than the folding bases typically used.  Backdrops and banners may also be wall mounted or held by suspension wires.

In this page, we briefly explain a little further about each of these as more detailed information is available elsewhere in the site about each of these possibilities.

Baseplates

We make several different bases to work with different widths of display.  For each folding base, there is also a baseplate alternative.  These are solid aluminium squares or rectangles which may be fitted with pole attachments via simple screw assembly.  Each is supplied with screws, pole attachments and an Allen key.

The image above shows a banner stand fitted with a baseplate rather than a folding base.

So the equivalents are:

See system in detail/base types.htm

The baseplates are sometimes used when a display is to semi-permanent rather than portable.  Baseplates are more costly than the folding bases and require a separate carry case if portability is required.

They are much flatter, height about 0.5cm versus the folding bases where height is approx 6cm.  When used up against a wall, the baseplates offer the advantage of having less depth than a folding base and so can get closer to a wall.

Adjustable Height Backdrop

Normally, our displays are fitted with what we call fixed height poles.  These are sectional and built up in a push fit manner.  We can create special fixed height poles to suit your requirements.

However, in circumstances where a little extra height is needed or when the height you need to display the graphic varies, you can use our telescopic poles instead of the fixed height poles.

The 2 piece telescopic pole is adjustable from 135cm through to 250cm.
The 3 piece telescopic pole is adjustable from 135cm through to 374cm.

Our telescopic poles are nicely engineered and feature a simple twist / lock action – so just unlock, set the height and then twist to lock in position.

See features and flexibility/adjustable height for further details

Double Sided Backdrop

In most cases, a single sided display is all that is required but if required, all of our banner stands and backdrops can be made double sided.

To do this, we use different clips to attach the graphics at the top and bottom of the display such that they accept a graphic panel on both sides rather than just the front face.  The first image on the right shows 2 graphics either side of the vertical pole on a Crossbase display stand.

See features and flexibility/double sided for further details

Ceiling Hanging & Wall Mounted Backdrops

It could be that you do not need a freestanding backdrop display.  This could be for reasons of cost, space limitations etc or perhaps you need more options than for a freestanding only display.

With our system, you can use the fabric backdrop (with rails top and bottom) and have the option to suspend this, either with hooks over a shell scheme wall or by using suspension wires.  This is because we can supply eyeleted clips which fit to the rear of the rails to allow this.

Additionally, we also have a wall mounting system whereby a different clip set is supplied with wall mounting fittings.

See hanging & mounting for further details.

Accessories

There are spotlights available for all of our systems.