Clips and Connectors

FLEX-clip top

As the name suggests, this clip is used for the top of displays. It fits over the top of the pole which allows the graphic to be tensioned from the bottom without the top of the display being able to slip down.

Single and double sided versions available.

Grip clip

The grip clip is used for the bottom of displays and has silicone bands to ensure the clip stays put and remains tensioned.

It is available in three sizes depending upon the pole type i.e classic, telescopic or jumbo.

Double grip clip

Used mainly at the bottom of displays to allow for a second graphic to be applied to the rear of a display making it double sided.

Clips over the grip clip.

Ceiling clips

These clips come complete with eyelets to allow suspension wires to be fitted thus creating a hanging banner.

The clips are available for single sided and double sided displays.

See hanging banners section for examples.

Wall mounting kit

Our wall mounting kit allows you to create stunning wall displays.

Simply screw the wall mounting block to the wall and use the double sided clip which comes with the kit to connect the display to the wall.

See wall displays section for examples.

Flexible joint

This connector really boosts the system flexibility. It is used for displays wider than 200cm and fits between two rails holding the graphics. It bends in the middle which means that wide 'one piece' graphics can simply be folded in half to make them more portable.

This flexibility also allows wide display to be used at an angle or straight.

See wide displays section for examples.

Flexible display connector

Joins displays at the top and bottom and has a flexible centre allowing the user to dictate the angle of the displays.

See joined displays section for examples.

Multi function clip/connector

Can be fitted with top clip fixture to be used at the top of very tall displays for greater stability. As it is eyeleted, it may also be used for ceiling mounted banners.

It may also be used to span two displays to either connect them or to stabilise a widescreen joint when it is used for straight displays

Corner clips

These new clips may be used for 60 degree and 90 degree corners.

They are used with our new square and triangular displays but they may also be used to form just one corner such as when joining side walls on an exhibition stand.