Component |
Description / Use |
| Cross base |
Basic stand in the shape of a cross - uses one pole to support media. |
| Twinbase |
A solid 60cm bar is positioned between the two feet to enable support of wider graphics - uses two poles to support media. |
| XL |
As per twinbase but 100cm bar used between feet to enable support of larger media - again uses two poles. |
| Square Plate |
A flat, more permanent alternative to the cross base. |
| Twin plate |
A flat, more permanent alternative to the twinbase. |
| Grip clip |
Basic way of connecting a horizontal graphic bar to the vertical poles. Uses a silicone strip to keep it in place. |
| Double grip clip |
Allows double sided Displays to be created. Clips over the back of a grip or FLEX-clip. |
| FLEX-clip (top) |
As with the grip clip, this clip attaches the horizontal graphic bar to the vertical poles but instead fits over the top of the vertical pole preventing it sliding down when heavy media is used. |
| FLEX-clip (bottom) |
For use with the telescopic pole (which has greater diameter than fixed poles). Slides over the pole and can be positioned anywhere or fixed using the small grub screw to the rear. |
| Single ceiling clip |
Use this eyeleted clip with suspension wires to hang a single sided banner. |
| Double ceiling clip |
Use this eyeleted clip with suspension wires to hang a double sided banner. |
| Wall mounting kit |
Includes screws, plugs and necessary connectors to wall mount a graphic. Use one kit every 0.5m width. |
| Classic pole |
Comes in various heights and in 1, 2 or 3 sections depending on portability required. Creates the Display height. |
| Telescopic pole |
Simple twist and lock mechanism allowing variable height between 135cm and 250cm. |
| Classic bar |
Aluminium extrusion for mounting media. Can be used with FLEX-tape or Velcro tape depending upon media being used. |
| Snaplock bar |
Aluminium extrusion with mechanical action. Used for mounting media (without the need for tape) by trapping within its jaws. |
| FLEXible Display connector |
Allows two single Displays of the same height to be joined at an angle. |
| Display connector bar |
Rigid bar used to connect two Displays of the same height in a straight line. |
| Wide screen joint |
Use this to make Displays greater than 2m wide with one piece graphic drops. It allows graphics to be used straight or angled and enables them to be folded away compactly. |
